Whether you’re a professional plumber or just want to give plumbing a try, you’ll need plumber’s putty. For leak-free, long-lasting protection around fixtures like faucets and drains, try this multipurpose compound. If you have any plumbing issue, contact PS Plumber services for booking appointment.
PS Plumber Singapore has extensive knowledge and do every task with perfection. In this comprehensive guide, we will discuss the basics of plumber’s putty, its many uses, and the best way to apply it.
Why Use Plumber’s Putty?
For an extended period of time, plumber’s putty keeps its softness and water tightness. It does not have sticky properties like silicone and other caulks. When you seal a fixture or drain portion with putty, it’s straightforward to remove and replace if needed.
Comparatively, silicone, various sealants, and caulk are more difficult to work with than plumber’s putty. If you find a mistake, simply remove it and do it again. It outperforms caulk when it comes to filling large gaps. It does not require any time to dry or cure. The fixture will be ready for usage as you finish.
How To Use Plumber’s Putty?
Hand shaping is required prior to applying plumber’s putty to the plumbing component. If you want to use plumber’s putty, wait until the surface is dry and clean of any debris, wax, oil, or grease. Dry the surface after removing debris using a cloth, scraper, or wire brush, if necessary.
To apply plumber’s putty, follow these simple steps:
- The first step in using plumber’s putty is to identify the material you’re working with. The next step is to figure out if ordinary plumber’s putty or stain-free plumber’s putty will work better for your project.
- After you’ve removed the amount of putty you want, close the container’s lid to keep any leftover putty clean. Shape the putty into a soft, flexible consistency by kneading it in your hands. The next step is to mold it into a rope or a long string that is approximately half an inch thick.
- Using the putty, draw a full circle around the bottom of the flange of the object you’re putting, blending the ends where they meet. Reshape and roll a longer rope if the one you have is too short.
- Put your product, whether a basket strainer, pop-up, shower drain, or bath waste, into place. When you tighten your product into position, any excess putty will seep out from under the flange and around the fixture. This means you’ve applied enough putty and created a continuous seal.
- Remove any extra putty by using a putty knife once the item has been secured. Rinse well. If you’re using putty in a chilly environment, give it ten minutes after you first install it to make sure it’s secure.
- Return the surplus putty to its original container if it is clean and devoid of any debris. To keep the putty clean and out of the air, be sure to screw on the lid tightly. The putty can dry out and become unusable if left out in the air for too long, as mentioned above.
Once the component is in place, you can start using the sink, faucet, or shower right away. To make sure there are no leaks, turn on the water after installation. Simply adding extra plumber’s putty can fix any leaks that may be present.
